| |
Comments for Unknown Case
Add a Comment
Al wrote on Monday, February 02, 2015 (PST):Looks to be a High Crop Case.
tumblerbob wrote on Monday, February 02, 2015 (PST):It appears to be a Case 470 based upon the "lines" thru the letters in the CASE logo.
Adirondack case guy wrote on Monday, February 02, 2015 (PST):It is either a 530 or 630. Those decals are totally incorect for that tractor. The sn# plates were rivited to a panal which mounts to the lower half of the fuel tank on the RH side, but missing in your pic. Bring your questions over to the Case DB discussion board on this site.
Joe Young wrote on Tuesday, February 03, 2015 (PST):You have an early (1960-1962) model Case 541C (a Case 530 with a 159 cubic inch Gas Engine, in the Row Crop configuration. with the Case-o-matic (torque converter) clutch). It appears it has a number of desirable options including power steering, wide front, and spin-out rear wheels. It will have an eagle hitch instead of a 3-point hitch, and one set double action hydraulic remotes plumbed to the rear of the tractor.
Dee wrote on Wednesday, February 04, 2015 (PST):Thanks very much for helping me ID my tractor! Your information sounded very professional and very definite. Thanks again!
Jeff wrote on Thursday, April 16, 2015 (PDT):It appears to be either a 430 or 530 row crop. If it has an eagle hitch it is likely an early model (1960 to 1964). The serial number should be on the right side of the dash cluster. The gear trans wiil have a hand clutch as well. Those graphics are not correct. There are correct ones available.
Jeff wrote on Thursday, April 16, 2015 (PDT):the hydraulic clutch you mentioned is either a shuttle or a caseomatic drive torque converter.
Jeff wrote on Thursday, April 16, 2015 (PDT):the hydraulic clutch you mentioned is either a shuttle or a caseomatic drive torque converter.
Jeff wrote on Thursday, April 16, 2015 (PDT):It appears to be either a 430 or 530 row crop. If it has an eagle hitch it is likely an early model (1960 to 1964). The serial number should be on the right side of the dash cluster. The gear trans wiil have a hand clutch as well. Those graphics are not correct. There are correct ones available.
Robert wrote on Tuesday, January 19, 2016 (PST):case400B made in 1957 or1958 had a one peaice dash and was caseomatic
|
Home
| Forums
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|